K-edge K13-510-[color] User Manual download pdf (Page 3)

WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!

Mount Installation:

NOTE: The K13-510 clamp is designed to function as a 'single-piece' clamp when installed properly, meaning that one end of

the clamp 'contacts' the arm first while the other end has a 'gap' for the final clamping pressure.

CAUTION: Due to the clamping design and bolt thread engagement, maintain a torque of 1.5 N-m MAX or bolt failure

will result.

1. Remove the 2x M3 x 8mm bolts from the upper clamp half (K13-512)

2. Install the mount onto the right side (driveside) of the stem on the 22.2mm time trial handlebar.

3. Install the upper clamp half (K13-512) back onto the lower clamp half (K13-511).

4. Install, but do not tighten, the 2x M3 x 8mm bolts back into the clamp assembly.

5. Tighten the INNER CLAMP BOLT (the bolt closest to the insert (K13-503)) fully to 1.25 N-m.

6. Position the mount to your desired position and 'lightly' tighten the OUTER CLAMP BOLT to hold that position.

7. Carefully torque the OUTER CLAMP BOLT to 1.25 N-m.

***IF you wish to adjust the 'tension' of lever action on the TT Mount, please proceed to " Lever Action Adjustment".

1 2 3 4 5

No comments

K-edge K13-510-[color] User Manual Page 3