K-edge K13-510-[color] User Manual download pdf (Page 4)

WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!

Lever Action Adjustment:

NOTE: The K13-510 is factory-assembled for immediate use with GARMIN Edge/ Forerunner computers without any

adjustment necessary, IF you wish to adjust the lever action of the TT mount, please follow the steps below to adjust the insert

(K13-503).

1. Loosen the 2x M3 x 6mm Flat Head Screws holding the K13-503.

2. Slowly tighten the 2x M3 x 6mm Flat Head Screws holding the K13-503 (see diagram above).

3. While tightening, check the lever action by rotating 90-Degrees until desired 'feel' is achieved.

4. Once a desired adjustment is met, install the GARMIN computer and check for any sign of play between the arm

(K13-511) and the insert (K13-503). IF play is detected, remove the computer, lightly tighten the 2 x M3 x 6 mm Flat

Head Screws holding the insert (K13-503) until play is eliminated, and desired lever action are both met.

Note: Approximate torque to achieve ideal lever action is 0.45 N-m (+/- 0.1 N-m). This allows for smooth action

while still maintaining a distinctive click at the end of each rotation of 90-Degrees.

Caution: Do not "over-torque" the M3 x 6mm Flat Head screws.

Note: A small amount of thread lock has been applied to the M3 x 6mm bolt at the factory, it is recommended that

an additional amount be added if this bolt were to be adjusted multiple times.

1 2 3 4 5

No comments

K-edge K13-510-[color] User Manual Page 4